Product Description
A filling and fairing compound. PU based, solvent-free, two-component. Applied by spatula and trowel to the underwater areas of wooden boat construction. Does not shrink when set in above-waterline areas. Easy to sand. Not to be thinned. Suitable for bonding all materials except polyethylene.
Curing time: 50 minutes. Drying time: Touch dry 3–5 hours, dust free 5–9 hours, fully cured 24 hours, full mechanical resistance 7 days.
Technical Properties
| Colour | : Cream |
| Volume Solids | : 100% |
| Mixing Ratio | : 4/1 |
| Flashpoint | : >60°C |
| Pot Life | : 0.5 hour |
| Cleaner | : Börf PU Thinner |
| Surface Temperature | : Min 10°C / Max 40°C |
Surface Preparation
Prior to application, the surface must be free of all contaminants and foreign matter, and must be clean and dry.
Usage Instructions
Substrate must be dry, clean and free from contaminants. Relative humidity must not exceed 90%. Mix components A and B thoroughly. Do not mix more than can be used within 0.5 hours. The product can be applied with a spatula, but a trowel and putty knife are preferred. Do not use below 10°C. Wear protective clothing, goggles and gloves. Refrain from smoking throughout the application.
Health and Safety
For further information regarding safety and health regulations, please refer to the label and the Safety Data Sheet (SDS).
Disclaimer
The information in this data sheet is provided to the best of our knowledge. However, we have no control over either quality or condition of the substrate and other factors affecting the use and application of this product. Therefore, we cannot accept any liability whatsoever or howsoever arising from the performance of the product or for any loss or damage arising from the use of this product. We reserve the right to change the product without notice.
