Navimare Glue 490 is a waterproof epoxy glue suitable for use in all marine applications involving gluing or bonding. Due to its non-sag properties, it can be used on vertical and other difficult areas.
Technical Properties
| Colour / Texture | : Semi-Transparent / Glossy |
| Volume Solids | : 93% |
| Specific gravity | : 1.1 gr/ml |
| Flashpoint | : >45°C |
Surface Preparation
All types of substrates should be dry and free from grease, waxes, salts and other contaminants. Sand the substrate before applying Navimare Glue.
Usage Instructions
Substrate should be dry and free from contaminations. Relative humidity should be less than 90% RH. Mix by volume two parts of pack A and one part of pack B well. Do not mix more glue than can be used in 30 minutes. Do not add thinner. The product can be applied by putty knives. Add the glue to both parts that are meant to be glued.
Application Data
| Mixing ratio by weight | : Base to hardener: 70 to 30 |
| Mixing ratio by volume | : Base to hardener: 67 to 33 |
| Potlife | : 30 minutes at 20°C |
| Dry film thickness per coat | : Not applicable |
| Wet film thickness per coat | : Not applicable |
| Cleaner | : Navimare Epoxy Thinner T-10 |
| Surface Temperature | : Min 5°C / Max 30°C |
Drying and Recoating Times
| Substrate temp. | Dry to recoat | Fully cured | Maximum recoating (1) |
| 10°C | 16 hours | 10 days | 4 days |
| 23°C | 6 hours | 5 days | 2 days |
| 30°C | 4 hours | 2 days | 1 day |
(1) The surface should be dry and free from salts and other contaminants prior to overcoating. When the maximum recoat time has been exceeded or after prolonged exposure times it is necessary to roughen the surface in order to ensure intercoat adhesion. When in doubt, consult your nearest Navimare office.
Health and Safety
Observe the precautionary notices on the label of the container. A material safety data sheet is available upon request and national or local safety regulations should be followed.
- Avoid skin and eye contact by wearing overalls, gloves, goggles, mask, etc.
- Spillage on the skin should immediately be removed by thorough washing with lukewarm water and soap or a suitable industrial cleaner.
- Eyes should be flushed with fresh water and medical attention sought immediately.
- Spraying should be carried out under well-ventilated conditions. Avoid inhalation of solvent vapours and paint mist by wearing an air mask.
- This product contains flammable materials and should be kept away from sparks and open flames. Smoking in the area should not be permitted.
Disclaimer
The information in this data sheet is provided to the best of our knowledge. However, we have no control over either quality or condition of the substrate and other factors affecting the use and application of this product. Therefore, we cannot accept any liability whatsoever or howsoever arising from the performance of the product or for any loss or damage arising from the use of this product. We reserve the right to change the product without notice.
