FEATURES
Easy Mixing
- Single component, aluminium pigmented
- Smooth consistency
Good Application Properties
- Non-sag properties
- Good spreadability
Excellent Resistance Properties
- Heat resistant up to 300°C
- Resistant to atmospheric conditions
- Resistant to mild solvents and fumes
RECOMMENDED USES
One-component physically drying silicon acrylic coating. Heat resistant up to 300°C. Navitherm 300 can be used over non-insulated surfaces such as carbon steel, galvanised steel and aluminium surfaces.
- Most metals
- Fibreglass composites
- Masonry
SPECIFICATION DATA
| Coating Type | : Silicon acrylic, single component |
| Color | : Aluminium |
| Density (at 20°C) | : 1.05 Kg/Lt. |
| Packaging | : Metal buckets 5.00 Lt and 20 Lt. |
| Gloss | : 0–35 Matt |
| Flash Point | : 27°C (Setaflash) |
| Cleaning Thinner | : Navi T-6 |
| Shelf life | : More than 1 year |
| VOC | : 570 gr/Lt. |
| Volume Solids | : 34% |
| Temperature Resistance | : Continuous 260°C; peak 300°C (dry) |
| Theoretical spreading rate | : 17 m²/Lt. at 20 mic. DFT (60 mic. WFT) / 8.5 m²/Lt. at 40 mic. DFT (120 mic. WFT) |
| Recommended film thickness | : 40 mic. Dry |
| Application | : Spray, roller, brush |
| Drying time (at 25°C, below 85% RH) | : Touch: 15 minutes. Walk on: 2 hours. Dry to overcoat: 2 hours. |
Surface Preparation
All metal surfaces must be cleaned to near-white condition equivalent to SSPC-SP-10 or Swedish Standard Sa 2½. Other surfaces must be clean, free of oil, dirt, release compounds and other foreign matter.
Mixing
Single-component material. Stir well before use to prevent settling.
Application
Apply the mixed components by air or airless spray or brush for small areas to the prepared surface. After full drying, panels that have been coated can be heated to 80°C for better film strength.
Precaution
Refer to material safety data sheet of the product. Additional safety information is available upon request. Minimum safety precautions in dealing with the paints are;
- Take precaution to avoid skin and eye contact (i.e. gloves, goggles, face mask, barrier creams, etc.)
- Provide adequate ventilation.
- If the product comes in contact with the skin, wash thoroughly with lukewarm water and soap or suitable industrial cleaner. If the eyes are contaminated flush with water (minimum 10 minutes) and obtain medical attention at once.
- Since these products contain flammable materials, keep away from sparks and open flames. No smoking should be permitted in the area.
- Observe all precautionary notices on containers.
Xn: Harmful for human health. F: Flammable. Warning signs: R11, R20/21/22, R36/38. Safety warnings: S2, S3/7/9, S16, S20/21, S24/25, S38.
Note
To the best of our knowledge, the information contained herein is accurate. However, Navimare-PX assumes no liability whatsoever for the accuracy or completeness of the information contained herein. Final determination of the suitability of any information or material for the use contemplated, the manner of use and whether there is any infringement of patents is the sole responsibility of the user. Additional information may be obtained through your local sales representative or Navimare-PX.
